On Legs

Most modules are designed with four legs, one in each corner. A few designs use two legs on one end and rely on the legs on the next module to support the other end. These modules, without the addition of optional legs, do not stand on their own. There is even an innovative design with one leg per module that relies on the entire assembly of modules to provide stability. Obviously, these modules do not stand on their own.

So how many legs should a module have?

Why three of course. Oh, and they should not be at the ends either.

Why three legs? For the same reason a tripod uses three legs. Three legs always touch the ground. How many times have you gone to eat and ended up at a table that wobbled? Tripods never wobble they merely tilt. Put a module on an uneven floor; on a module with a very sturdy frame, it will wobble just like a table; on a flexible frame, which is the vast majority of modules, the frame will flex to compensate for small variances and only wobble for large variances. Avoiding flex is the first step in maintaining solid and reliable modules.

Continue reading “On Legs”

On Frames

The most basic part of a modular standard is the frame that supports the track work and scenery.

There are two basic designs that predominate in the design of frames for modules.

The first one is a simple box with a top and no bottom. The sides of the box are wood and the top used to be plywood but now is most likely foamboard. This is what Linn Westcott in his book How to Build Model Railroad Benchwork refers to as butt-joint benchwork.

The other design is two end plates attatched to a top plate and conformable side plates usually of masonite. It is also a simple box but has more free-flowing design capabilities.

What they share in common is that the frame is supposed to be fairly rigid to keep the track work at the proper angle to the floor and to other track work. The old frames with plywood tops were fairly rigid because you had a five sided wooden box with a lot of nails and/ or screws holding it together. The new style box is only four sided since the top is usually just plopped on. I see this all the time. The builder may put braces around the outside edge to keep the foam in place (and they think from sagging–but they are wrong) but rarely do you see any real cross-bracing or even “bed slats” to keep the foam from sagging. They flex and flop like a dead herring.

Continue reading “On Frames”