B.T.S. – Flagstop Station

The doors

Next were the two doors. I tackled the freight door first. The only challenge was bending a pleasing set of handles from the supplied wire.

My first attempt at the freight door handles. I did not like it

The second attempt. Much better

Freight door handles bent, cut and ready for installation

Freight door handles in place

The depot door presented a small challenge. On my kit, when the inner and outer door panel were lined up the trim around the window had a large trim at the bottom of the window and no trim at the top. I fixed this by offsetting the rear panel slightly low on the front panel and sanding off the overhanging rear panel section.

The front door before glazing and door knob

I had to offset the rear panel to get the window trim to center in the front panel opening

Door in place and complete